Abutment minimal thickness at screw

Discussion in 'exocad' started by bigbrush, Feb 1, 2019.

  1. bigbrush

    bigbrush Well-Known Member

    Hello,
    who can tell me how to modyfy the minimal thickness at the screewchannel.
    I think there is a xml-file anywhere.
    thanks a lot Abut-1.png
     
  2. fdbfrse

    fdbfrse New Member

     
    leshi and jmn like this.
  3. Rigant

    Rigant Active Member


    I think it's the minimum thickness of everything proyect, or at least, I dont know how change the thickness only for the screewchannel...:hungover: and you will not have problems to change the minimum thickness in the workparemetes.exerocking
     
  4. bigbrush

    bigbrush Well-Known Member

    Thank you for your answers. tried like in the video to minimise the radius, but didn`t work perfect. So will search in workparameters.
     
    Rigant likes this.
  5. Rigant

    Rigant Active Member

    In many occasions, I minimize the minimum thickness due to problems in the emergency profile or in the screw channel, it is not a problem if you understand that it could be a risk in breakage.;)
     
  6. leshi

    leshi Well-Known Member

    This minimum thickness can be set in the library. At the moment I do not have dongle, can you try to make a test with another library?
     
    cadfan likes this.
  7. 2thm8kr

    2thm8kr ɹotɐɹʇsıuıɯqA Staff Member

    I looked in the implant editor software to find place to change this. I didn't find it.

    I looked in the implant library xml files as well, nothing.

    SC thickness.PNG

    I think this is where you are going to have to make the changes:
    D:\exo6645\DentalCADApp\config\defaultparameters

    SC thickness2.PNG
     
    cadfan and Rigant like this.
  8. Rigant

    Rigant Active Member


    yes, but I think that the minimum thickness of the project is the one that commands... :hungover:
     
  9. bigbrush

    bigbrush Well-Known Member

    Hello 2thm8ker,
    I tryed, but it doesnt work :(
     
  10. Rigant

    Rigant Active Member

    I know... ok, try this:
    1.go to ".../Exocad/deltaldb/bin" and run "workparameterstool.exe"

    2.change the minimal thickness, for example for a anatomic crow in metal:


    Workparameters.jpg


    Workparameters2.jpg

    3. open new dental db and maybe new proyect... and in the options select the correct minimal thickness:

    Workparameters3.jpg


    But be careful, its very low parameter...

    This work for my... i hope u too!
     
    Last edited: Feb 7, 2019
    AttilaBalint and 2thm8kr like this.

Share This Page