Anatomic Waxup

Discussion in 'exocad' started by DevonR, Jan 18, 2019.

  1. DevonR

    DevonR Active Member

    Can anyone please explain why the design is not fitting to the crown bottoms and just closing it in flat?
     

    Attached Files:

  2. dougola

    dougola Well-Known Member

    Did you define margins?
     
  3. DevonR

    DevonR Active Member

    yes
     
  4. 2thm8kr

    2thm8kr ɹotɐɹʇsıuıɯqA Staff Member

    You set up job in DB as pontic waxup?

    To get it to fit the model use the editor to cut the bottom of the design off.
    Start new job as waxup/copy mill, mark margins and exocad will create bottoms for the crowns.
     
  5. DevonR

    DevonR Active Member

    I did start it as waxup/copy mill. marked the margins, exo created the bottoms but then when it merged, it closed the bottoms right through the model

    baffling
     
  6. DevonR

    DevonR Active Member

    so we ended up having to split it into 2 teeth and connecting them. For some reason it didn't accept 1. All is good.
     

Share This Page