design help

Discussion in 'exocad' started by Toothman19, Jan 9, 2015.

  1. Toothman19

    Toothman19 Well-Known Member

    is there an easier way to design this? Ive never designed something like this before and I wasn't really sure what to do.
    The doc wants to basically do a reduced screw retained bridge and then glue crowns on top of it
     

    Attached Files:

  2. Zero Zero

    Zero Zero Guest

    Split crown on abutment...
     
  3. cadfan

    cadfan Moderator Staff Member

    And use multi unit interface this doesent work because different insertion axis ( either cut them later with a burr ) and save as slm after that smooth the margin an start again with the split crown . Set the abutment bottom to zero to get a better smoother transition btw fixed form of the abutment and freeform ( the part in the middle that looks like a small ring )
     

Share This Page