Post-Cores, is there a better way

Discussion in 'exocad' started by Elab, Jan 24, 2020.

  1. Elab

    Elab Active Member

    Hey guys, a couple years ago I made a few post-cores by scanning the model and impression, merging the files etc... Doable but to time consuming, analog was faster.

    Is there a digital way now that’s faster, easier or better than analog ?
     
  2. 2thm8kr

    2thm8kr ɹotɐɹʇsıuıɯqA Staff Member

    Draw up some post designs with different diameters, but same top design. Print them up, scan in place. Make an "implant" library and use the posts like scan bodies.
    Pretty sure there is a thread here somewhere about this and some stl files of different diameters as well.
     
    mill3d likes this.

Share This Page