Discussion in '3D Scanners' started by juan carlos, Feb 27, 2016.
dental scanner circuit board for smartoptic 101
how much ?
I had a couple of those before.
The DSP circuit board broke on One of mine.
I trashed it.
I'm sorry but I do not understand . could you explain?. thanks for write
My english is bad ( sorry)
You have Texas Instruments DLP circuit board bad?
You take apart the scanner yet?
Nope....those are not the problem I think.
Why you have Two different type of fuse?
You replace One before?
Check device manager.... administrador de dispositivos
¿Ves el escáner en la lista? Tal vez mal cable USB o el enchufe ? Pruebe el nuevo cable y probar diferentes puerto USB ? ¿Ha tenido que volver a instalar ningún software o ventanas recientemente?
¿Su explorador tiene USB y VGA se conecta a la PC ?
PC show not connected.
You maybe have simple Windows driver issue?
Tomorrow....send me teamviewer numbers please.
(Private message of course!)
That scanner has too many data voids.
I hate it myself.
I throw mine into basura.
ok my friend
We look tomorrow.
I have a smart optical 800 semiautomatic and works very well.
I wanted to have this because it was automatic .but did not have many differences.
Have the SmartOptics 800 chamaleon camera and two USB ports.
This SmartOptics 101 has guupy camera and cables are firewire and serial.
I did not expect so many differences.
I think throw my money down the drain.
but if you can not be fixed I appreciate your hep
life goes on
That was my least favorite scanner of all time.
I have had over 100 scanners.
Do you want a Steinbichler scanner? To add to exocad?
$3000 for STI and $8500 for STII
This is what we use, and often the DOF Freedom HD.
I have Five New DOF Freedom HD also.
Did you change PC recently?
What hardware of software change you made to create these problem?
If nothing....then I would guess your projector is caca.
It is Texas Instruments technology DLP chip.
ready my teamvier
I'm ready !
I think he fixed it.
Try to contact the Ch'ti cadman I think he has this part ....
hello my friend I'm outside the laboratory.
thanks for your help
I communicate with you soon
Hello my friend, I'm sorry but I had things to do.
Might help me again.
The situation is this:
in a 32-bit pc work fine.
the problem is that my exocad 2015 does not work well in 32 .Solo 64-bit correctly work.
install again all in one 64bit.
but I find an error. (photo)
could you help me
I do not know you did but revived the escanner.
you could do it again for this pc 64-bit. I can pay you for this service via paypal.
looks like your cameradriver isn`t installed.
Go to folder 3d-scanner in programms / tools ( picture 1) and serch your camera ( picture 2). Mine is PGR ( usb device ).
Install and new start, should work.
Separate names with a comma.