smartoptics 101 dental scanner circuit board

Discussion in '3D Scanners' started by juan carlos, Feb 27, 2016.

  1. juan carlos

    juan carlos Member

    Hello my friend
    This scanner work whit exocad 2015

    IMG_2188.JPG IMG_2189.JPG
  2. DeNon

    DeNon New Member

    Hi, thanks, it's good news for me. But in set there is no any cd or usb flash with drivers or something like that. It could be a problem to me, to start work with it? Or not? Its hard to install this scanner in pc? Maybe pc has had some special things inside, or not? Thanks:))
  3. bigbrush

    bigbrush Well-Known Member

    Pc is not speciali5 or 7, 8gb ram and nvidia grahic will work. But you need scansoftware and key to work with. Best is to contact smart optics, they are very helpfull.
    best regards Tom
  4. DeNon

    DeNon New Member

    Thank you Tom,
    As I understant, exoscan wouldn't help me:/ ok, I will try to contact them:)
  5. juan carlos

    juan carlos Member

  6. juan carlos

    juan carlos Member

  7. DeNon

    DeNon New Member

    Thank you very much Juan. I can't wait when I will start to work with it. It's a little step for world, but big form me:)
    DMC likes this.
  8. kostisg

    kostisg New Member

    Hi do you know where i can find specs for smart optics activity 840?

    Στάλθηκε από το SM-A510F μου χρησιμοποιώντας Tapatalk
  9. CoraDias

    CoraDias New Member

    Hi...The method I always use to remove parts that are bad anyways is to get a nail clipper, clip the leads off flush with the board on both sides, add a little new solder or electronics flux, then use a can of compressed air and a soldering iron to clean out the holes. I personally prefer the compressed air method to the solder-sucker method, as it seems to clean the hole out better.
    DMC likes this.
  10. MartyMacFly

    MartyMacFly New Member


    Firstly, I would like to thank you team. You realy help me with all you data you have posted on this forum about this scanner.
    I have a smartoptics scanner for a personal use. not for business. This scanner was replaced by new one more faster and accurate by my previous company.
    Anyway, I'm working in a cad cam and in the 3D print domain during now 11 years. But today I'm blocked. :) Yes in fact my scanner show this message: pmtloaderror (see the picture attached ). when i start the application. it look likes an issue of the Calibration file. If you have an idea or can help me it will be very cool :).

    Best regards

    Attached Files:

  11. DMC

    DMC Scott Hudson

    I think you need that file from old pc or from a disk. It is common to have a machine specific cal file, or a file that matches your calibration part serial number.
    cadfan likes this.
  12. cadfan

    cadfan Moderator Staff Member

    windows search pmt file hope you have in real live a insurance windows for dummies always backup if you wont feel the finger deep in your a.. maybe via windows restore point or ask SO
  13. MartyMacFly

    MartyMacFly New Member

    Bonjour Messieurs,
    Thanks for your answers. Ok I will try first to check if we have it in our old backup. Then I will ask in parallele my contacts at SmartOptics.
    Best regards

Share This Page