Steinbichler ST I magnet too weak

Discussion in '3D Scanners' started by greenhat, Jan 2, 2019.

  1. greenhat

    greenhat New Member

    My Steinbichler STI scanner's magnet for the model holder seems to be too weak.
    When I put two stone models in occlusion into the scanner, the thin metal plate separates from the lower model plate.
    Since I have this scanner I just use a cable tie to hold these plate together which works perfectly.
    Is there any solution to this problem?
     
  2. Erykd1

    Erykd1 Member

    Happens to me too. When I scan the bite, I rubber band around the model as well as the two plates, keeping the rubber band away from the magnet. This is only for full arch upper/lowers. Quads can be held just fine on mine.
     
    2thm8kr likes this.
  3. DMC

    DMC Scott Hudson

    I made double magnet kit.

    You want one?

    I have one or two in stock
     
    2thm8kr likes this.
  4. DMC

    DMC Scott Hudson

  5. Erykd1

    Erykd1 Member

  6. DMC

    DMC Scott Hudson

    You can have it.

    Send me your original back if you like it.

    I'll ship today
     
  7. Erykd1

    Erykd1 Member

    Thanks mate, Meg should have the address. K&S in Phoenix. Really appreciate it :)
     

Share This Page