Sum3d and Roland PDI fixture

Discussion in 'CAM software' started by fschiopu, Jun 22, 2019.

  1. fschiopu

    fschiopu New Member

    Hi,

    I have an old Roland JWX-10 from a friend and thought about getting a PDI fixture for discs (https://www.pdi3d.com/PDI_Round_Material_Fixture_p/pdi-rmf.htm). I contacted them and they confirmed it works with sum3D but will need the MDX-40 or DWX-30 post processor. I'm currently using the sum3D with a Lava Mill and is the only post processor I see in the machines folder. Anyone done this before ?
     
  2. leshi

    leshi Active Member

    Can your Dongle for Sum3d use Roland machines? You need to check this too.
     
  3. fschiopu

    fschiopu New Member

    How do I check?
     
  4. leshi

    leshi Active Member

    Ask CIMsystem. Send your dongle number to support. If you are from New York, then you need to ask your question here support@cimsystemusa.com
     
  5. fschiopu

    fschiopu New Member

    Thank you. Will do.
     

Share This Page