wax milling parameters in 3shape

Discussion in '3shape software' started by sidesh0wb0b, Jun 17, 2017.

  1. DMC

    DMC Prime Dental Products

    Messages:
    4,002
    Likes Received:
    1,946
    Trophy Points:
    113
    We see this prepline strategy separate but it is no longer necessary.

    Sum3d added command for change during internal spiral. We start with tight step for first couple millimeter then make larger step to finish spiral. Same tool of course.

    Maybe cadfan prefer to use smaller tool at prep line?
     
  2. sidesh0wb0b

    sidesh0wb0b Member

    Messages:
    42
    Likes Received:
    9
    Trophy Points:
    8
    all i know is there was a slight issue with the radius settings given to me by uncle hank. guess i shouldnt be shocked at that one haha. once properly set the fits are where they should be. ive not adjusted anything having to do with the mill.
     
  3. 2thm8kr

    2thm8kr ɹotɐɹʇsıuıɯqA Staff Member

    Messages:
    2,781
    Likes Received:
    1,685
    Trophy Points:
    666
    Follow the lead by Uncle Hank if your striving for mediocrity at best.
     
  4. sidesh0wb0b

    sidesh0wb0b Member

    Messages:
    42
    Likes Received:
    9
    Trophy Points:
    8
    i rarely do, but sadly CAP went that route...had i known prior to purchasing i would have gone elsewhere.
     

Share This Page