Ring STL?

Discussion in 'Wanted Ads' started by Rigo De Leon, Oct 7, 2016.

  1. Rigo De Leon

    Rigo De Leon Member

    Anyone arround here got some ring stl files. I would like to print some of them.. Thanks
  2. DMC

    DMC Scott Hudson


    Attached Files:

    Kongo-Otto likes this.
  3. DMC

    DMC Scott Hudson

    When will we see 4k projectors in little table-top printers? Then we will see the next step in evolution for the little Digital projector printers. either 4x the build area, or much better resolution from current gen. printers.

    I have been using and servicing and selling (used) 3d systems Projet 3000, 3500, 3510.

    We have bought and sold and serviced many 3d printers near you, like Zombor at Best-cast for example.

    Most Jewelry guys prefer the wax found in only 3d systems CPX printers, and Solidscape. They (3d systems) are pain in the asshole to keep running and require a large initial investment of course, but by far the number Jewelry printer still Globally.

    You have run-in with Rich (Dick) Motto yet? lol

    I had a Solidscape 11years ago. Too slow. Only Two jets which require fidding-fokking with often I guess? 1980s technology still.

    I guess they never (Sanders/Solidscape) had the money to upgrade to a Xerox or Mistubishi or other printhead with hundreds of jets? Instead they still use old style Fuel-injector pintel design that wears out and changes mass and size jetted out during it's life span. Really not much changed since the first Sanders printer, right?

    The Piezo drivers in the Xerox printhead do not wear out and common to get 5 years+ out of a printhead. Then, I change them for a few hundred if needed.
    Last edited: Nov 13, 2017
  4. DMC

    DMC Scott Hudson

    Your SolidScape can probably print this, but not the Tiger?


    Attached Files:

  5. DMC

    DMC Scott Hudson

    Check out this geometry.
    Saves precious metal, while looking cool and big design.
    geometry flower.jpg
  6. DMC

    DMC Scott Hudson

  7. DMC

    DMC Scott Hudson

    You can post them pretty little stl files right here!

    Like I did a few posts up.

  8. Chris Silvoy

    Chris Silvoy Well-Known Member

    I am messing around with a 2k desktop printer and the hardest part is finding great resins and printing dozens of times to get great printing profiles.
    I DL'd the first ring design you posted and will give that a stab today. Mind posting the stl of the second design and I will give that a shot?
  9. DMC

    DMC Scott Hudson

    It is already posted.
    Finish your coffee and look again
    I have posted 2 ring files in this thread.
  10. Misuke

    Misuke New Member

    hmmm would upload some .stls from rings ...but get an error when uploading … file is.zip and about 155 MB
  11. 2thm8kr

    2thm8kr ɹotɐɹʇsıuıɯqA Staff Member

    @Mr3d @DMC
    cadfan likes this.

Share This Page