Small Lifehack: Interface instead of Scanmarker )

Discussion in 'exocad' started by Vasyl, Jan 14, 2020.

  1. Vasyl

    Vasyl Well-Known Member




    RDCLarry, adipas and 2thm8kr like this.
  2. 2thm8kr

    2thm8kr ɹotɐɹʇsıuıɯqA Staff Member

    This working pretty reliably for you? I've wanted to do the same with Straumann temporary cylinders for SR abutments.
  3. Vasyl

    Vasyl Well-Known Member

    I did one job when I didn’t have the necessary scanmarker. Then repeated when he wrote the article )

    This is hardly suitable for permanent work. But if sometimes it is necessary - it should work.
    As an alternative to manual positioning )
    adipas, Rigant, 2thm8kr and 1 other person like this.
  4. adipas

    adipas Well-Known Member

    spasybi Vasyl ! :)
    Vasyl likes this.
  5. Attila Gergely

    Attila Gergely New Member

    hehe good one this can be applied to analogs as scan markers to get implant position as well
    Last edited: May 10, 2022

Share This Page